![]() ![]() Arm your alarm system than firmly strike the windshield pillar with the open palm of the hand considering the force required to break the vehicle glass. The pre-detect stage will operate at 30% less force than the full trigger stage.ġ. The sensitivity of the pre-detect stage, (indicated by the Red LED flashing rapidly), and full trigger stage, (indicated by the Red LED turning on momentarily) are set with one setting. Note: The shock sensor's LED's will not operate unless the alarm system is armed. Route the small 4 pin connector of the harness toward the alarm control module and connect it to the mating 4 pin connector on the alarm unit. Connect the large 4 pin connector of the wiring harness to the 4 pin mating connector on the AS-9495-4P (NR).Ģ. Mount the sensor using the two screws provided or cable ties securing it to your chosen location.ġ. An alternate location can be the "A" pillar,"B"pillar, or suspended from an existing brace or wiring harness.Ģ. Ideally the inside firewall, center of the vehicle is best for sensitivity. Select a solid mounting location inside the vehicle. Always mount the components and route the wiring away from the rotating steering shaft assembly.Always mount the sensor within 22" of the alarm module to assure the plug in cable reaches the sensor.ġ. Never mount any component near hot or moving parts. Never mount the sensor outside the vehicle where it will be exposed to the elements. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |